c171196

I re-did my problem again: I have got "mbam.exe Applicarion Error" message after I installed the current version 1.50 and applied for update data. As which the message is below: The instruction "0x10003d70" referenced memory at "0x000____" The memory could not be "read". My system is using Windows XP and Symantec Endpoint. I tried to remove and use Safe mode to reinstall mbam v1.50 but no luck still the same. (Then, I tried your advise but no hope:)Please use this method for a clean reinstall of V1.50 - Make sure you disable your Symantic as you install the new copy of V1.50 then check for other updates - To Fully Remove and Reinstall a Fresh New Copy of Malwarebytes - Read Carefully Windows XP: Click on Start and select Control Panel Open Add/Remove Programs Uninstall Malwarebytes' Anti-Malware Restart your computer very important ! Download and run mbam-clean.exe from ->Here It will ask to restart your computer, please allow it to do so, very important After the computer restarts, temporarily disable your Anti-Virus and install the latest version of Malwarebytes' Anti-Malware from ->Here (Then, today I found from Event Viewer:)I have look Under Event Viewer of Application in which indicated the EventID:1000 and description is Faulting application mbam.exe, version 1.50.0.0. faulting module msvbvm60.dll, version 6.0.98.2, fault address 0x000e450a. I hope this may help and look more details into my causing problem. Please advise me. ******** My system is using Windows XP SP3 and Symantec Antivirus Coropration v10.1.8.8000 not the Symantec Endpoint. ********

Hi: I have look Under Event Viewer of Application in which indicated the EventID:1000 and description is Faulting application mbam.exe, version 1.50.0.0. faulting module msvbvm60.dll, version 6.0.98.2, fault address 0x000e450a. I hope this may help and look more details into my causing problem. Please advise me.

Hi: I did reply you yesterday that your steps which not applied to solve this problem. Please reply me here how to overcome the problem. There will be a lot of viewer wants to know how to solve it not only me want to know. Please advise me.

Hi: Not long before you answer my question I have already done the same ways you have told me the steps to reinstall mbam 1.50 however the application error and error message still the same. That is never happen before with the mbam down grade version. Please advise me again. Thanks

Hi: I have got "mbam.exe Applicarion Error" message after I installed the current version 1.50 and applied for update data. As which the message is below: The instruction "0x10003d70" referenced memory at "0x000____" The memory could not be "read". My system is using Windows XP and Symantec Endpoint. I tried to remove and use Safe mode to reinstall mbam v1.50 but no luck still the same. Any ideas? How to solve it? Please advise me. Thanks